- Home & Workshop Products
All pivot points on the loader have grease fittings that are accessible from the side of the loader to make greasing the loader much easier, ensuring that all grease points are more likely to be serviced. No more searching for grease points that are hard to find. Removing the grease gun from the grease fitting is not a problem as sufficient radius has been left to allow the grease gun tip to be rotated to the side for removal from the fitting.
|Select up to 4 models to compare specifications||
|Front tire||25x8.50-14 4PR R4|
|Rear tire||15.00-19.5 4PR|
|Front axle configuration|
|Pump capacity||5.3 gpm|
|Rated pressure||2495 psi|
|Bucket weight||93 kg
|Lift capacity at full height||Measured at pivot (U)
539 kgMeasured at 500 mm ahead of pivot (V)
|Lift capacity at 59 in. (1500 mm)||Measured at pivot (W)
588 kgMeasured at 500 mm ahead of pivot (X)
|Boom breakout force||Measured at pivot (Y)
760 kgfMeasured at 500 mm ahead of pivot (Z)
|Bucket rollback force capacity||At maximum height (VV)
639 kgfAt 59-in. (1500-mm) lift height (XX)
809 kgfAt ground-level line (ZZ)
|Dimensions||Maximum lift height (A)
2140 mmAt full height - bucket level(B)
1979 mmAt full height - bucket dumped (C)
|Overall length (I+F), ft (m)||9.5 ft
|Overall height in carry position (J)||5 ft
|Digging depth (H)||5 in.
|Reach||At maximum height (D)
603 mmAt ground level - bucket level (F)
|Bucket angle||Dump angle, degrees (E)
43.8 degree (angle)Rollback angle, degrees (G)
31.4 degree (angle)Dump angle, ground
122 degree (angle)
|Cycle times||Loader raise, seconds
3.31 secondsLoader lower, seconds
2.75 secondsBucket dump, seconds
1.75 secondsBucket rollback, seconds
Materials buckets are available to match tractor and loader applications.
May be used for loading dirt, gravel, feed, and light materials as well as scraping, digging, and other general purpose tasks.
IMPORTANT: Materials buckets are not recommended for heavy-duty tasks. For heavier use applications, use heavy-duty bucket.
Top surface of the bucket is parallel to cutting edge, which aids operator as a leveling guide.
Quik-Change connection for easy on and off.
Round-back design helps material flow when filling or dumping the bucket.
A hood guard can be ordered for a tractor without ordering a loader.
The hood guard protects the front of the tractor while operating the loader.
The bolt-on design stays with tractor when loader is removed.
With BW15872 parking stand kit, the D160 Loader can now be quickly and easily removed from the tractor without tools.
The BW16127 parking stand kit allows for the D170 Loader to be parked from the tractor.
The kit includes the following: